[uanog] OSPF over GRE over IPSec
Volodymyr Melnyk
v.melnyk at tucha.ua
Fri Mar 11 18:22:22 EET 2022
Можна сконфігурувати OSPF як unicast, якщо multicast не є обов'язковим.
------ Original Message ------
From: "Volodymyr Litovka" <doka at funlab.cc>
To: "List, Uanog" <uanog at uanog.kiev.ua>
Sent: 11.03.2022 18:08:41
Subject: Re: [uanog] OSPF over GRE over IPSec
>Зібрав аналогічну конфігурацію з мікротом, включим там пакет-сніфер,
>підтверджується -
>
>він (мікрот) не отримує OSPF hellos з тунелю.
>
>Проблема явно на боці linux. Де?!?! :)
>
>On 11.03.2022 16:48, Volodymyr Litovka wrote:
>>Привіт,
>>
>>допоможіть, будь ласка, з наступною конфігурацією.
>>
>>Є GRE over IPSec в транспортному режимі між лінухом (ubuntu 20.04) та
>>cisco (virtual XE v17.07.01). Пінги ходять - тобто власне зв'язок
>>встановлюється,
>>IPSec policies are ok, але OSPF (FRR 8.1) не піднімається.
>>
>>tcpdump на боці лінукса показує відправку hello в цей інтерфейс, але
>>Cisco не бачить з тунелю нічого:
>>
>># tcpdump -i gre1 -v
>>[ ... ]
>>15:34:49.132222 IP (tos 0xc0, ttl 1, id 15017, offset 0, flags [none], proto OSPF (89), length 68)
>> my_linux > ospf-all.mcast.net: OSPFv2, Hello, length 48
>> Router-ID x.x.x.x, Backbone Area, Authentication Type: none (0)
>> Options [External]
>> Hello Timer 10s, Dead Timer 40s, Mask 255.255.255.252, Priority 1
>> Neighbor List:
>> 100.100.8.1
>>
>>Cisco:
>>
>>Mar 11 15:31:33.522: OSPF-1 HELLO Tu8: Send hello to 224.0.0.5 area 0 from 100.99.0.65
>>Mar 11 15:31:42.586: OSPF-1 HELLO Tu8: Send hello to 224.0.0.5 area 0 from 100.99.0.65
>>Mar 11 15:31:51.641: OSPF-1 HELLO Tu8: Send hello to 224.0.0.5 area 0 from 100.99.0.65
>>
>>Мені йдеться, що проблема на боці лінукса, але я не можу зрозуміти, що
>>я роблю не так. Хтось має досвід запуску такої конфігурації та може
>>щось порадити?
>>
>>Конфігурація linux (mtu узгоджені, multicast встановлено):
>>
>>6: gre1 at NONE: <POINTOPOINT,MULTICAST,NOARP,UP,LOWER_UP> mtu 1400 qdisc noqueue state UNKNOWN group default qlen 1000
>> link/gre x.x.x.x peer x.x.x.y
>> inet 100.99.0.66/30 brd 100.99.0.67 scope global gre1
>> valid_lft forever preferred_lft forever
>>
>>interface gre1
>> ip ospf cost 5
>> ip ospf mtu-ignore
>>
>># sh ip ospf interface gre1
>>gre1 is up
>> ifindex 6, MTU 1400 bytes, BW 0 Mbit <UP,POINTOPOINT,RUNNING,NOARP,MULTICAST>
>> Internet Address 100.99.0.66/30, Broadcast 100.99.0.67, Area 0.0.0.0
>> MTU mismatch detection: disabled
>> Router ID x.x.x.x, Network Type POINTOPOINT, Cost: 5
>> Transmit Delay is 1 sec, State Point-To-Point, Priority 1
>> No backup designated router on this network
>> Multicast group memberships: OSPFAllRouters
>> Timer intervals configured, Hello 10s, Dead 40s, Wait 40s, Retransmit 5
>> Hello due in 8.701s
>> Neighbor Count is 1, Adjacent neighbor count is 0
>>
>>конфігурація cisco:
>>
>>interface Tunnel8
>> description HZF
>> ip address 100.99.0.65 255.255.255.252
>> ip mtu 1400
>> ip ospf network point-to-point
>> ip ospf cost 5
>> tunnel source GigabitEthernet1
>> tunnel destination x.x.x.x
>>
>>Tunnel8 is up, line protocol is up
>> Internet Address 100.99.0.65/30, Interface ID 20, Area 0
>> Attached via Network Statement
>> Process ID 1, Router ID 100.100.8.1, Network Type POINT_TO_POINT, Cost: 5
>> Topology-MTID Cost Disabled Shutdown Topology Name
>> 0 5 no no Base
>> Transmit Delay is 1 sec, State POINT_TO_POINT
>> Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
>> oob-resync timeout 40
>> Hello due in 00:00:04
>> Supports Link-local Signaling (LLS)
>> Cisco NSF helper support enabled
>> IETF NSF helper support enabled
>> Can not be protected by per-prefix Loop-Free FastReroute
>> Can be used for per-prefix Loop-Free FastReroute repair paths
>> Not Protected by per-prefix TI-LFA
>> Index 1/8/8, flood queue length 0
>> Next 0x0(0)/0x0(0)/0x0(0)
>> Last flood scan length is 1, maximum is 38
>> Last flood scan time is 0 msec, maximum is 1 msec
>> Neighbor Count is 0, Adjacent neighbor count is 0
>> Suppress hello for 0 neighbor(s)
>>
>>
>>на боці FRR я бачу осьо таке:
>>
>># sh ip ospf neigh
>>
>>Neighbor ID Pri State Dead Time Address Interface RXmtL RqstL DBsmL
>>100.100.8.1 1 Init/DROther 37.960s 100.99.0.65 gre1:100.99.0.66 0 0 0
>>
>>на боці Cisco - нічого, бо вона не бачить Hello від Лінукса.
>>
>>Дякую за будь-які поради.
>>
>>--
>>Volodymyr Litovka
>> "Vision without Execution is Hallucination." -- Thomas Edison
>--
>Volodymyr Litovka
> "Vision without Execution is Hallucination." -- Thomas Edison
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.uanog.kiev.ua/pipermail/uanog/attachments/20220311/7be01484/attachment-0001.html>
More information about the uanog
mailing list